Megger EVCA210-UK Electric Vehicle Charge Point Adapter 
 
New electric vehicle charge point adapter
The Megger EVCA210/EVCA210-UK are compact, simple to use adapters designed to perform all the functions
required by the electrical contractor to fully test Mode 3 AC Electric Vehicle Charge-points.
Specially designed to comply with UK, European and other International wiring regulations and standards,
the Megger EVCA210/EVCA210-UK may be used on all single and three phase electric vehicle charge points, with 
appropriate connectors.
They are designed to test the function and safety of a charging point. The adapters allow you to conduct tests using
appropriate single or multifunction test instruments (Megger MFT1741+) on EV charging points in accordance with IEC/EN 61851-1 and IEC/HD 60364-7-722.

 Charging points should be tested as part of the initial installation and repeated periodically.
 
 
   EVCA210  
EVCA210-UK 
 
 Input voltage 250V (single phase system) / 430 V (three phase system),
 YES
YES
 
 Push Button for PE Pre-Test
 YES
YES
 
 Rotary switch providing PP State simulation
 YES
YES
 
 Rotary Switch providing CP State simulation
 YES
 YES
 
 Push button for CP Error �E� simulation
 YES
 YES
 
 Push button for PE Error (Earth Fault) simulation
 YES
 YES
 
 Measurements on live conductors (L1, L2, L3 and N) and on PE conductor
 YES
YES
 
 Mains Socket: EVCA210-UK - 13A UK socket 
                           EVCA210 - Schuko socket (CEE 7/3)
 YES
 YES
 
 CP signal test, two 4 mm ports for connection to an oscilloscope
 YES
 YES
 
 CAT II 300 V
 YES
YES
 
 IP Rating IP54
 YES
 YES
 
 Type 2 Plug for charging points with panel mounted socket outlet or fixed cable with vehicle connector.
 YES
 YES
 
 Type 1 Plug for charging points with fixed cable and vehicle connector 
 NO
 YES
 
 Soft Carry Case
 YES
 YES
 
What's in the box EVCA210-UK (UK Mains Socket) :
Megger Type 1 Charging Plug
Megger Type 2 Charging Plug
Soft Carry Case
Instruction Manual